Publish Time: 2017-06-26 Origin: Site
light will be bright,open draining.
(21) SPIN: Manual switch key.Effective when manual and no washing state.When effective the LED night will be bright,output draining;press again,close spinning and drain,LED light will be off:
When spinning oil is effective,running according to the following table:
| Spinning step | Output | Time | Remark |
| 1 | Positive Running Z | 10 seconds | Output is accordind to the choosing washing speed |
| 2 | Positive Running Z+D1+D2 | 110 seconds | After spinning all the water then enter into next step,manual or after final rinsing,spinning time is 170 seconds |
| 3 | Positive Running Z+D3 | 60 seconds | This step must be operated when manual,but when automatic it is according to whether there are middel-spinning or not then output |
| 4 | Positive Running Z+D1+D3 | 25 seconds | When low speed spinning,, press this output it will run,no limite to the time controlling;or after finishing operating this step then enter into the next one |
| 5 | Positive Running Z+D2+D3 |
| Middle speed spinning |
| Positive Running Z+D1+D2+D3 |
| High speed spinning |
Att: After finishing spinning oil,it will lock all the motors for 45 seconds.
3. Automatic program parameter setting
Press “ROGRAM SELECT” key to choose the programs,press SET key,enter into setting state.
After enter into setting state:
Water input time,washing time,rinsing time,temperature and operating will flash,press ▲ or ▼ to adjust washing time,range is 0-99 minutes;Press wash ▲ or ▼ key to adjust water entry time,range is 0-99 minutes;Press Spin ▲ or ▼ key to adjust rinsing temperature,range is 0-99℃；Could set with middle speed spinning or not when cold water,hot water,steam and drain;
Press “SELECT” key, Water input time, rinsing time,temperature and operating will flash, press ▲ or ▼ to adjust rinsing time,range is 0-99 minutes; ;Press wash ▲ or ▼ key to adjust water entry time,range is 0-99 minutes;Press Spin ▲ or ▼ key to adjust rinsing temperature,range is 0-99℃；Could set with middle speed spinning or not when cold water,hot water,steam and drain;
ress ▲ or ▼ to adjust rinsing time,,adding water time and rinse time will flash, press ▲ or ▼ to adjust rinsing times,range is 0-9 times;Press “WASH” SELECT to adjust adding water’s time,range is 0-99 minutes;
Press “SELECT” key,spinning time will flash,press ▲ or ▼key to adjust parameters,range is 0-9 minutes;
In the state of setting,press “MEMORY” key will record it and quit setting state.
4. Running
Automatic running:
There are five sets of automatic programs: alterable,common,spot, wollens and polyster.
Press “PROGRAM SELECT” key to select program,press “START/STOP” key will run automaticly.Running:
| Step | Running | Time | Remark |
| 1 | Water input | 3 minutes | Adjustable |
| 2 | Wash | Program setting | When setting time is 0,there are not step 1-3 |
| 3 | Spin | 240 seconds | It is 180 seconds without middle speed |
| 4 | Water input | 5 minutes | Adjustable |
| 5 | Rinse | Program setting | Water input and rinse operating at the same time |
| 6 | Spin | 180 seconds | 150 seconds without Middle speed spinning;spining time is 240 seconds after final rinsing |
| 7 | Spin | Program setting |
|