Step-1 Introduction of Barrier Washer Extractor
Load Side of Barrier washer extractor
Unload side of barrier washer extractor
When Get the machine ,Please put the barrier washer extractor in the right place as designed
Please set up wall where mark “ Partition area “ on the machine
Step 2 Take off transportation bar
When the machine is in the right position ,Please take off the transportation bar ,which is to protect shock absorbing system of Barrier Washer Extractor
Please note : This bar is painted in red and there are two piece at each side
Step 3 After the “bar “ is took off ,please connect air to the machine
Step 4 ,After connect air ,please connect water to the machine ,if the machine is heated by steam , connect the steam as well
Step 5 Put door opening/close handle to the Handle holder
There are four handles for each machine ,and two pieces of handle at each side