Installation Manual of Inventer Hydro Extractor-3

3) low speed turning , meanwhile ,the cloth brake turn forward : press green button on the button box ,the motor (inner drum ) will turn forwarder ,meanwhile cloth  will load from top brake

4 ) high speed  rotation : after load the cloth according to the above instruction ,  as soon as you close the cover , the machine will enter high speed rotation

Low speed reverse cloth brake to unload cloth :  after the motor completely stop  ,you can press yellow button REV , the motor of inner will reverse to unload the cloth

Note : the cloth here means very long cloth such as 100m cloth or 200m cloth ,if your fabric is not such long ,you don’t need to use support brake

3 during the process of spinning ,the following condition happen may cause the motor to stop to protect itself .

1) Press stop button at button box or emergence stop button at electricity controlling box

2) open the cover during the process of running

3)during the high speed running , the running power indicator at supporting brake is on  , the timer reach the set up time , the high speed running tie is off

4 for other reasons ,the invent try to protect itself ,,the invent will stop any form of output , meanwhile make warning with alert  and the drum will has no brake at all ,it will turn till it lose inertia , at this moment ,please wait till the motor 100% stop that the drum stops  , and according the code showed by invent to check trouble  ,after trouble solved then you can run the machine