Electricity introduction of Flatwork Ironer

双滚烫平机电气部分说明

The introduction of electric part for ironing machine with two drums.

电器部分简述：

Brief of electric equipment

电器控制部分主要由变频器、电动机及相关控制电路组成；可根据慰烫织物的要求，调节不同的熨烫速度.

Controlling part mainly consists of transducer,motor and correlative controlling circuit;ironing speed can be adjust according to the requirement of ironing fabric.

1.      主要电器参数：

Parameter of main electric equipment

〈1〉电     压（V）：～380（三相四线）

     Voltage(V):~380(three phase four wire)

〈2〉频    率（HZ）：50

    Frequency(HZ):50

〈3〉电机功率（KW）：2.2

     Motor power(KW):2.2

2.操作面板说明：

  Introduction of controlling panel

   操作面板由转速数显表、电源、过载指示灯及启动、停止按扭组成；（图1）

   Controlling panel consists of rotate speed display, power,over loading indicator light,button for start and stop.

3. 操作方式：

  Controlling mode:

   启动：按启动键，调节调速电位器、机器即运行

   Start:press the key of start,adjust and timing electric station,then it runs.

   停止：按停止键，机器即停止运行

   Stop:Press the key of stop,then it stops running.

* 安全旋扭必须处于复位位（即弹出），否则机器无法启动；

  Safe button must be in the position of reposition,or it can not be started.

4.安全设置：

Security setting:

机器左右侧各有一只安全按扭和安全挡板开关，当按下其中一只按扭或推动安全挡板，机器立刻停止运行並关机；

There si one security button and security baffle switch on each side of the machine,when press one of these two buttons,it will be stopped running at once.

5.附件资料：

  Attachment:

  LG-iG5变频器使用手册

  Using manual for LG-iG5 transducer

  三位半数显盘面板使用说明书

  Introduction for three and a half display panel

  电器原理图

Element chart for electric equipment