Auto steam Boiler Operation Instructions -2

(4)

1.    When the machine is used, please ensure it is protected by the ground line.

2.    When the machine comes to the market, all the components have been adjusted.  You should not adjust then ramdemly or replace them with other high capacity relief valve, insurance equipment or other components transferred, it is because there is some atmosphere in the water pump after it is out of water. You can open the out-water hole of the pump and let the air off.

3.    After three month’s using, you should knock down the electrothemal pope and clean the scale of the pot to ensure the steam volume, the purity of steam and make the service life longer.

4.    The pressure controller and the safety valve should be tested and adjusted by local stand measuring bureau.

5.    When it is under the cooling state, the insulation resistance should be over mega-ohm

6.    When you check and change some components, please cut off the power source, let off the remaining steam.

Special attention please: after one year’s using make the machine tested by local stand measure bureau. As well as it is qualified, it can be used.